YOKOGAWA ScopeCorder DL950 - Chapter 4: Triggering

Chapter 4
Triggering
Main Control Areas Used in This Chapter
You can also use the touch panel.
Jog dial
MENU key
Arrow keys
Soft keys
Touch panel
MANUAL key
Operation Modes Applicable to the Sections in This Chapter
ü
: Applicable, -: Not applicable
Section Scope Mode Recorder Mode
4.1 Setting the Trigger Mode
ü
-
4.2 Setting the Trigger Position, Trigger Delay, Trigger Delay, and Hold-off
ü
-
4.3 Triggering on an Edge Trigger (Simple) in Scope Mode
ü
-
4.4 Triggering on an Time Trigger (Simple) in Scope Mode
ü
-
4.5 Triggering on an External Trigger (Simple)
ü
-
4.6 Triggering on a Power Line Signal (Simple)
ü
-
4.7 Triggering on a Logic Trigger (Simple)
ü
-
4.8 Triggering on an A to B(N) Trigger (Enhanced)
ü
-
4.9 Triggering on an A Delay B Trigger (Enhanced)
ü
-
4.10 Triggering on an Edge On A Trigger (Enhanced)
ü
-
4.11 Triggering on an OR or AND Trigger (Enhanced) in Scope Mode
ü
-
4.12 Triggering on a Period Trigger (Enhanced)
ü
-
4.13 Triggering on a Pulse Width Trigger (Enhanced)
ü
-
4.14 Triggering on a Wave Window Trigger (Enhanced)
ü
-
4.15 Triggering on an Edge Trigger in Recorder Mode -
ü
4.16 Triggering on a Time Trigger in Recorder Mode -
ü
4.17 Triggering on an OR or AND Trigger in Recorder Mode -
ü
4.18 Triggering the Instrument Manually (Manual Trigger)
ü ü
* The settings may vary depending on the operation mode.