YOKOGAWA ScopeCorder DL950 - Connecting to a Network Drive

20-9
IM DL950-02EN
20.5 Connecting to a Network Drive
This section explains the following settings for accessing a network drive through an Ethernet
connection to load or save various instrument’s data:
Items Common to Scope Mode and Recorder Mode
• FTP server (file server)
• Login name
• Password
• Turning FTP passive mode on and off
• Timeout
• Connecting to and disconnecting from network drives
► “Network Drive (Net Drive)” in the Features Guide
UTILITY Network Menu
1.
On the waveform screen’s MENU, tap OTHERS > UTILITY, or press UTILITY.
2.
Tap Network, or press the soft key. The following screen appears.
Select Network.
Configure the FTP server. ► sec. 20.3
Configure the Web server. ► sec. 20.4
Configure the TCP/IP settings
► sec. 20.2
Configure mail settings. ► sec. 20.6
Configure network printing. ► sec. 20.8
See “Configuring Network Drive Settings
and Making a Connection.”
Configure SNTP. ► sec. 20.7
Configure the TCP/IP settings
► sec. 20.2 (/C60 option)
Configuring Network Drive (Network Drive) Settings and Making a
Connection
3.
Tap Network Drive, or press the soft key. The following screen appears.
Set the login name (up to 15 characters).
Set the password (up to 15 characters).
Set the timeout value (1 to 60 s).
Disconnects from the network drive
Set the FTP server’s host name.
Connects to the network drive
Selects 1G or 10G (displayed for the /C60 option)