YOKOGAWA ScopeCorder DL950 - Using Instrument as USB Storage Device

23-8
IM DL950-02EN
23.5 Using the Instrument as a USB Storage Device
This section explains the setting that enables you to use the instrument as a USB storage device
through a USB connection made between the USB port on the instrument’s side panel and a PC.
Items Common to Scope Mode and Recorder Mode
• Setting the USB function
► “Remote Control (Remote Ctrl)” in the Features Guide
UTILITY Remote Ctrl Menu
1.
On the waveform screen’s MENU, tap OTHERS > UTILITY, or press UTILITY.
2.
Tap Remote Ctrl, or press the soft key. The following screen appears.
Select Remote Ctrl.
Set USB Function to Storage.
Set Device to USB.
Note
• When USB Function is set to Storage, only this instrument’s internal SSD can be used as a storage
device. You cannot access any other storage device that are connected to the instrument.
• When you access this instrument’s internal SSD from a PC, only perform read and write operations.
Otherwise, the instrument may be damaged.
• When USB Function is set to Storage and files are being accessed, do not remove the USB cable or turn
off the instrument. Otherwise, the instrument may be damaged.
• When USB Function is set to Storage, do not access this instrument’s internal SSD from the instrument’s
menu.
• When you set USB Function to TMC, you can control this instrument from a PC via USB. For details, see
the Communication Interface User’s Manual, IM DL950-17EN, contained in the CD.