YOKOGAWA ScopeCorder DL950 - Configuring Voltage Measurements (16-CH)

2-12
IM DL950-02EN
2.2 Configuring Voltage Measurements (on 16-CH
temperature/voltage input modules)
This section explains the following voltage measurement settings for the 16-CH temperature/
voltage input module:
Scope Mode
• Turning waveform input or and off
• Display update rate
• All sub channel settings
(Display label, input coupling, zoom method (DIV/SPAN) switching, vertical zoom (vertical zoom,
offset), upper and lower display range limits, linear scaling)
• Display setup (display group)
• Zoom method (DIV/SPAN) switching
• Vertical zoom (vertical zoom, offset), upper and lower display range limits
• Turning the inverted waveform display on and off
• Sample rate
• Linear scaling
• Vertical scale (V/div)
• Vertical position
Recorder Mode
• Turning waveform input or and off
• Display update rate
• All sub channel settings
(Display label, input coupling, measurement range, upper and lower display range limits, linear
scaling)
• Display setup (display group)
• Upper and lower limits of the display range
• Turning the inverted waveform display on and off
• Sample interval
• Linear scaling
• Measurement range
► “Voltage Measurement” in the Features Guide