YOKOGAWA ScopeCorder DL950 - Configuring Strain Measurements

2-23
IM DL950-02EN
2.5 Configuring Strain Measurements
This section explains the following settings for strain measurements:
Items Common to Scope Mode and Recorder Mode
• Turning waveform input or and off
• Display label
• Sensor
• Executes strain balancing
• Filter (bandwidth limit, digital filter)
• Display setup (display group)
• Display range settings
• Range unit
• Inverted waveform display
• Sample rate and sample interval settings
• Linear scaling
• Measurement range
► “Strain Measurement” in the Features Guide
Channel Setup Menu
1.
On the waveform screen’s MENU, tap VERTICAL > CH, or press CH. A channel setup menu
appears.
(You can also tap the channel information display area at the top of the screen to display the
channel setup menu.)
2.
Tap a channel you want to configure, or select it using the jog dial or up and down arrow keys.
Turns the waveform
input on or off
Channel setup menu (1/2)
Channel setup menu (2/2)
Set the display range.
► sec. 2.1
Turns the inverted
display on or off
Set the range unit.
(µSTR, mV/V)
See “Sensor Setup.”
Executes the strain
balance
Set the display label.
See “Setting the Linear
Scaling (701271 shunt
calibration).”
Set the bandwidth limit and
digital filter. ► sec 2.1.
Display settings
► sec. 2.1
Set the sample rate.
(Scope mode)
Set the sample interval.
(Recorder mode)
► sec. 2.1