YOKOGAWA ScopeCorder DL950 - Triggering on Edge (Recorder Mode)

4-25
IM DL950-02EN
4.15 Triggering on an Edge Trigger in Recorder
Mode
This section explains the settings that are used when triggering on a specific edge in Recorder
mode.
Applicable in Recorder Mode
• Trigger source
• Trigger slope
• Trigger level
• Trigger hysteresis
• Pre-trigger
► “Trigger Source (Source),” “Trigger Slope (Slope),”
“Trigger Level (Level),” “Trigger Hysteresis (Hysteresis),”
“Pre-Trigger (Pre Trigger)” and “Edge Trigger(Edge)” in the Features Guide
Trigger Menu
1.
On the waveform screen’s MENU, tap TRIGGER > MENU, or press TRIG.MENU. A trigger
menu appears.
The Trigger menu appears only when Acquisition Condition in the waveform acquisition
conditions is set to Capture On Trigger.
Set the pre-trigger.
Select Edge.
See “Setting the Trigger
Source.”
Set the trigger slope.
( , , )
Set the trigger level.
Select Edge.
See “Setting the Trigger
Source.”
Set the trigger slope ( , ).
Set the pre-trigger.
Set the trigger hysteresis.
( , , )
For input other than logic
For logic input
Note
If linear scaling is applied to the trigger source, set the trigger level using a linearly scaled value.