YOKOGAWA ScopeCorder DL950 - Configuring Voltage Measurements

2-2
IM DL950-02EN
2.1 Configuring Voltage Measurements (on
modules other than 16-CH temperature/voltage
input modules)
This section explains the following settings for voltage measurements:
Scope Mode
• Turning waveform input on and off
• Display label
• Input coupling
• Probe attenuation and current-to-voltage conversion ratio
• Filter (bandwidth limit, digital filter)
• Display setup (display group)
• Zoom method (DIV/SPAN) switching
• Vertical zoom (vertical zoom, offset), upper and lower display range limits
• Adjustment (DC offset cancellation, gain adjustment)
• Turning the inverted waveform display on and off
• Sample rate
• Linear scaling
• Vertical scale (V/div)
• Vertical position
Recorder Mode
• Turning waveform input on and off
• Display label
• Input coupling
• Probe attenuation and current-to-voltage conversion ratio
• Filter (bandwidth limit, digital filter)
• Display setup (display group)
• Upper and lower limits of the display range
• Adjustment (DC offset cancellation, gain adjustment)
• Turning the inverted waveform display on and off
• Sample interval
• Linear scaling
• Measurement range
► “Voltage Measurement” in the Features Guide