YOKOGAWA ScopeCorder DL950 - Configuring Temperature Measurements

2-18
IM DL950-02EN
2.3 Configuring Temperature Measurements (on
modules other than 16-CH temperature/voltage
input modules)
This section explains the following settings for temperature measurements:
Items Common to Scope Mode and Recorder Mode
• Turning waveform input or and off
• Display label
• Input coupling
• Thermocouple type
• Filter (bandwidth limit, digital filter)
• Display setup (display group)
• Upper and lower limits of the display range
• Temperature unit
• Sample Rate and Sample Interval
• Temperature settings (RJC, burnout on/off, Bmode, attenuator settings)
► “Temperature Measurement” in the Features Guide
Channel Setup Menu
1.
On the waveform screen’s MENU, tap VERTICAL > CH, or press CH. A channel setup menu
appears.
(You can also tap the channel information display area at the top of the screen to display the
channel setup menu.)
2.
Tap a channel you want to configure, or select it using the jog dial or up and down arrow keys.
Turns the waveform
input on or off
Set the display label.
Set input coupling to TC.
Set the thermocouple type
(K, E, J, T, L, U, R, S, B, N, W,
Au7Fe).
Set the bandwidth limit and
digital filter. ► sec 2.1.
Set the temperature
unit (°C, K).
See “Temperature
Setup.”
Channel setup menu (1/2)
Channel setup menu (2/2)
Display settings
► sec. 2.1
Set the display range.
► sec. 2.1
Set the sample rate.
(Scope mode)
Set the sample interval.
(Recorder mode)
► sec. 2.1