YOKOGAWA ScopeCorder DL950 - Setting Display Conditions for X-Y Waveforms

6-3
IM DL950-02EN
6.2 Setting the Display Conditions for X-Y
Waveforms
This section explains the following settings for the display conditions of X-Y waveforms:
Items Common to Scope Mode and Recorder Mode
• Display range
• Turning pen markers on and off
• Main window’s display ratio
• Window layout
• Turning combine display on and off
• Interpolation
• The number of data points that are used to display waveforms
• Turning trace-clear-on-start on and off
► “X-Y Waveform Display” in the Features Guide
X-Y menu
1.
On the waveform screen’s MENU, tap DISPLAY > X-Y, or press SHIFT+DISPLAY(X-Y). The
X-Y menu appears.
Set the trace.
► sec. 6.1
Displays the second
page of the menu
X-Y menu (1/2)
Set the display interpolation (OFF, Line).
Displays the first page of the menu
X-Y menu (2/2)
Set whether to clear waveforms at
the start of acquisition (ON/OFF).
Set the cursor.
► sec. 6.3
Set the pen marker.
Set the main window’s display ratio.
(50%, 20%, 0%)
Set the window layout (Side, Vertical).
Select whether to superimpose
Window1 and Window2 (ON/OFF).
Set the number of data points that are
used to display waveforms (2k, 100k).