2-42
IM DL950-02EN
2.10 Configuring the Monitoring of LIN Bus Signals
(/VCE option)
This section explains the following settings for monitoring LIN bus signals.
Items Common to Scope Mode and Recorder Mode
• Turning waveform input or and off
• LIN frame reading settings (all sub channel settings, factor and offset settings of all sub channels,
frame settings, port settings, definition file loading)
• Individual sub channel scales
• Display group
• Scaling of all sub channels
• Sample rate and sample interval settings
► “LIN Bus Signal Monitoring (/VCE option)” in the Features Guide
Channel Setup Menu
1.
On the waveform screen’s MENU, tap VERTICAL > CH, or press CH. A channel setup menu
appears.
(You can also tap the channel information display area at the top of the screen to display the
channel setup menu.)
2.
Tap a channel you want to configure, or select it using the jog dial or up and down arrow keys.
Turns the waveform input
on or off
Displays the second
page of the menu
See “Setting the Scale and
Display Groups.”
See “Configuring LIN Frame
Reading Settings.”
Channel setup menu (1/2)
Set the scaling of all sub channels
(All SubChannel Auto,
All SubChannel Default)
Channel setup menu (2/2)
Displays the first page of the menu
Set the sample rate.
(Scope mode)
Set the sample interval.
(Recorder mode)
► sec. 2.1
To Next Page
Loading...
Need help?
General
