YOKOGAWA ScopeCorder DL950 - Performing GO;NO-GO Determination with Waveform Parameters

14-5
IM DL950-02EN
14.2 Performing GO/NO-GO Determination with
Waveform Parameters
This section explains the following settings for performing GO/NO-GO determination with
waveform parameters:
Applicable in Scope Mode
• Selecting the mode
• Judgment conditions
► “Waveform Parameter (Parameter)” and
“Automated Measurement of Waveform Parameters” in the Features Guide
GO/NO-GO Menu
1.
On the waveform screen’s MENU, tap ANALYSIS > GO/NOGO, or press SHIFT+MEASURE
(GO/NO-GO). The following screen appears.
Set the action. ► sec. 14.1
Set the determination period (start).
Set the determination period (end).
Set Type to Parameter.
See “Setting Judgment Conditions.”
Set the mode to ON.