20-8
IM DL950-02EN
20.4 Monitoring the Instrument’s Display from a PC
(Web Server)
This section explains the following settings for connecting to the instrument from a PC over a
network to show the instrument’s display on the PC and to start and stop waveform acquisition from
the PC:
Items Common to Scope Mode and Recorder Mode
• User name
• Password
• Timeout
• Connecting to the instrument from a PC
► “Web Server (FTP/Web Server)” in the Features Guide
UTILITY Network Menu
1.
On the waveform screen’s MENU, tap OTHERS > UTILITY, or press UTILITY.
2.
Tap Network, or press the soft key. The following screen appears.
Select Network.
See “Configuring the Web Server.”
(For information on the FTP server,
see section 20.3.)
Configure the TCP/IP settings
► sec. 20.2
Configure mail settings. ► sec. 20.6
Configure network printing. ► sec. 20.8
Configure the network drive. ► sec. 20.5
Configure SNTP. ► sec. 20.7
Configure the TCP/IP settings
► sec. 20.2 (/C60 option)
Configuring the Web Server (FTP/Web Server)
3.
Tap FTP/Web Server, or press the soft key. The following screen appears.
Set the user name (up to 15 characters).
Set the password (up to 15 characters).
Set the timeout (30 to 3600).
Applies the settings
Selects 1G or 10G (displayed for the /C60 option)
To Next Page
Loading...
