YOKOGAWA ScopeCorder DL950 - Measuring FFT Waveforms with Cursors

12-8
IM DL950-02EN
12.3 Measuring FFT Waveforms with Cursors
This section explains cursor measurements of FFT waveforms.
Items Common to Scope Mode and Recorder Mode
• Turning the cursors on and off
• Cursor type
Marker cursor
• Source waveform
• Marker position
• Marker form
• Measurement items
Peak cursor
• Measurement time period
• Measurement items
► “Maker Cursor (Maker)” and “Peak Cursor (Peak)” in the Features Guide
FFT Menu
1.
On the waveform screen’s MENU, tap ANALYSIS > FFT, or press FFT. The following screen
appears.
Set the FFT. ► sec. 12.2
Turns FFT Window on or off
► sec. 12.1
See “Setting the Cursors.”
FFT menu (1/2)
Set the trace. ► sec. 12.2
Set the FFT math range.
► sec. 12.2