YOKOGAWA ScopeCorder DL950 - Setting X-Y Waveform Trace

6-2
IM DL950-02EN
6.1 Setting the X-Y Waveform Trace
This section explains the following settings for displaying X-Y waveforms:
Items Common to Scope Mode and Recorder Mode
• Turning X-Y waveform display on and off, source waveform (X axis, Y axis)
• Start and end points of display range
► “X-Y Waveform Setup (Setup)” in the Features Guide
X-Y menu
1.
On the waveform screen’s MENU, tap DISPLAY > X-Y, or press SHIFT+DISPLAY(X-Y). The
X-Y menu appears.
Turns the display on or off
Select the window that you want to edit.
See “Selecting Traces.”
Set the display range start and
end points.
Set the cursor. ► sec. 6.3
Set the pen marker. ► sec. 6.2
Displays the Next menu. ► sec. 6.2
Selecting Traces
2.
Tap Setup, or press the soft key. The following menu appears.
Turns the display on or off
For a 16-CH Temperature/Voltage Input
Module, set at the sub channel level.
Set the X-axis trace.
Set the Y-axis trace.
Set the serial bus input at the bit level.
Set XY1 to XY4 on Window1 and XY5 to XY8 on Window2.