YOKOGAWA ScopeCorder DL950 - Measuring X-Y Waveforms with Cursors

6-4
IM DL950-02EN
6.3 Measuring X-Y Waveforms with Cursors
This section explains the following settings for measuring X-Y waveforms with cursors for each
cursor type:
Items Common to Scope Mode and Recorder Mode
• Turning cursor measurement on and off
• Cursor type
• Source waveform
• Moving cursors
• Measurement items
• Marker assignment
• Marker position
► “X-Y Waveform Cursor Measurement (Cursor)” in the Features Guide
X-Y Cursor Menu
1.
On the waveform screen’s MENU, tap DISPLAY > X-Y, or press SHIFT+DISPLAY(X-Y). The
X-Y menu appears.
2.
Tap Cursor, or tap the soft key.
X-Y menu (1/2)
FFT cursor menu
Set the cursor.
Turns cursor on or off
See the explanation of each cursor.
Set the pen marker.
► sec. 6.2
Set the trace.
► sec. 6.1