YOKOGAWA ScopeCorder DL950 - Triggering on External Signal (Simple)

4-8
IM DL950-02EN
4.5 Triggering on an External Trigger (Simple)
This section explains the settings that are used when triggering on an external signal.
Applicable in Scope Mode
• Trigger source
• Trigger slope
► “Simple Trigger (Simple)” and “Trigger Source (Source)” in the Features Guide
Trigger Menu
1.
On the waveform screen’s MENU, tap TRIGGER > MENU, or press TRIG.MENU. A trigger
menu appears.
Set the trigger position, trigger delay, and hold-off
► sec. 4.2
Select Simple.
Set the trigger source to External.
Set the trigger slope ( , ).
Set the trigger mode. ► sec. 4.1