YOKOGAWA ScopeCorder DL950 User Manual

9-4
IM DL950-02EN
9.2 Searching History Waveforms
This section explains the following settings for searching history waveforms:
Applicable to Scope Mode
• Search mode
• Executing searches
Zone
• Target zone (Zone1 to Zone4)
• Search conditions
• Search window (upper and lower limits, left and right boundary values)
• Search logic
Parameter
• Target parameter (Param1 to Param4)
• Search conditions
• Source waveform and parameter
• Reference range (upper and lower limits)
• Search logic
• Parameter measurement range
► “History Waveform Display/Search (Scope mode only)” in the Features Guide
HISTORY menu
1.
On the waveform screen’s MENU, tap ANALYSIS > HISTORY, or press HISTORY
(ANALYSIS).
See “Executing a History Waveform Search.”
(Changes to Clear Trace when Search Mode is set to OFF (see section 9.1)).
Set the search mode (OFF, Zone, Parameter).
See “Searching Using a Zone” or “Searching by Automatically
Measured Parameter.”
Set the display mode. ► sec. 9.1
Set the highlight display. ► sec. 9.1
Set the display range. ► sec. 9.1
Displays a list of history waveforms ► sec. 9.1

YOKOGAWA ScopeCorder DL950 Specifications

General

Brand	YOKOGAWA
Model	ScopeCorder DL950
Category	Test Equipment
Language	English