4-21
IM DL950-02EN
4.13 Triggering on a Pulse Width Trigger (Enhanced)
This section explains the following settings for triggering on a pulse width trigger:
• Trigger source
• State condition
• Determination mode
• Reference time
• Trigger conditions (trigger level, hysteresis)
► “Pulse Width Trigger (Enhanced)” in the Features Guide
Trigger Menu
1.
On the waveform screen’s MENU, tap TRIGGER > MENU, or press TRIG.MENU. A trigger
menu appears.
Set the trigger position, trigger delay, and hold-off
► sec. 4.2
Set the trigger mode. ► sec. 4.1
Select Enhanced.
Set the trigger type to Pulse Width.
See “Setting the State and
Trigger Conditions.”
To Next Page
Loading...
Need help?
General
