17-2
IM DL950-02EN
17.1 Power Analysis (Power)
This section explains the following settings for performing power analysis:
Items Common to Scope Mode and Recorder Mode
• Power analysis mode
• Selecting power analysis items
• Power analysis reset
► “Power Math (/G05 option)” in the Features Guide
Power Analysis Menu (Power)
1.
On the waveform screen’s MENU, tap ANALYSIS > ANALYSIS, or press SHIFT+HISTORY
(ANALYSIS).
2.
Tap Power, or press the soft key. A power analysis menu appears.
See “Setting the Power
Analysis Mode.”
Configure harmonic analysis.
► sec. 17.2
Configure power
analysis.
Set the numeric display.
Display Group: Numeric display of
the waveforms registered in the
display group
Power: Numeric display of power
analysis
Harmonic: Numeric display of
harmonic measurement
Setting the Power Analysis Mode (Analysis Mode)
3.
Tap Analysis Mode, or press the soft key. The following screen appears.
Set the analysis mode.
See “Setting the Power Analysis Source.”
Set one analysis
source.
Set two analysis
sources.
Resets the integrated value of Wiring System1
Resets the integrated value of Wiring System2
(Appears when the analysis mode is set to 2Wiring)
Resets the integrated value of Wiring System1 and 2
(Appears when the analysis mode is set to 2Wiring)
Menu when the analysis mode is 2 Wiring System
To Next Page
Loading...
