YOKOGAWA ScopeCorder DL950 - Saving Setup Data

19-16
IM DL950-02EN
19.5 Saving Setup Data
This section explains the following settings for saving setup data: You can save setup data to a file.
Items Common to Scope Mode and Recorder Mode
• Save destination
• File name
• Saving setup data
► “Saving Setup Data (setup)” in the Features Guide
FILE Setup (Save) Menu
1.
On the waveform screen’s MENU, tap FILE > FILE, or press FILE.
2.
Tap Setup under Save, or press the soft key. The following screen appears.
Select Setup.
Starts saving
Set the file name. ► sec. 19.4
Set the save destination.
► sec. 19.4
Saving Setup Data (Save Execute)
• You can save the setup data (the setup information of each key at the time that the file is saved)
to a file. The extension is .SET.
• The date, time, and communication setup parameters are not saved.
• You cannot save setup data during waveform acquisition. Press START/STOP to stop the
waveform acquisition.