YOKOGAWA ScopeCorder DL950 - Using Accumulate Feature (Scope mode)

5-9
IM DL950-02EN
5.5 Using the Accumulate Feature (Scope mode)
This section explains the following accumulation settings:
Applicable in Scope Mode
• Turning accumulation on and off
• Number of times to accumulate waveforms
► “Accumulation (Accumulate)” in the Features Guide
Display Menu
1.
On the waveform screen’s MENU tap DISPLAY > DISPLAY, or press DISPLAY. The Display
menu appears.
Turns accumulation on or off (Scope mode only)
Set the number of times to accumulate waveforms
(Infinite, 2, 4, 8, 16, 32, 64, 128).
Set the display format. ► sec. 5.1
Select the display group you want to edit.
► sec. 5.1
Set the grid. ► sec. 5.3
Detail setup ► sec. 5.4
Set the waveform arrangement, color, and grouping.
► sec. 5.2
Set the interpolation method. ► sec. 5.3
Setting Accumulation (Accumulate)
2.
Tap Accumulate, or tap the soft key. If you set this to ON, the accumulation count appears.
3.
Set the accumulation count by tapping the displayed accumulation count or by using the jog
dial or up and down keys. If you set this to Infinite, accumulation will continue until acquisition
is complete.