YOKOGAWA ScopeCorder DL950 - Triggering on OR or AND (Enhanced) (Scope Mode)

4-17
IM DL950-02EN
4.11 Triggering on an OR or AND Trigger (Enhanced)
in Scope Mode
This section explains the following settings for triggering on an OR or AND trigger:
Applicable in Scope Mode
• Trigger source
• Edge detection condition (OR trigger)
• Achievement condition (AND trigger)
• Trigger conditions (trigger level, hysteresis)
► “OR Trigger (Enhanced)” and
“AND Trigger (Enhanced)” in the Features Guide
Trigger Menu
1.
On the waveform screen’s MENU, tap TRIGGER > MENU, or press TRIG.MENU. A trigger
menu appears.
Select Enhanced.
Set the trigger type to OR or AND.
See “Setting the State and
Trigger Conditions.”
Set the trigger position, trigger delay, and hold-off
► sec. 4.2
Set the trigger mode. ► sec. 4.1