YOKOGAWA ScopeCorder DL950 - Performing Continuous Statistical Processing

11-7
IM DL950-02EN
11.2 Performing Continuous Statistical Processing
This section explains the following setting for performing continuous statistic processing on the
displayed waveforms:
Items Common to Scope Mode and Recorder Mode
• Turning statistical processing on
► “Continuous Statistical Processing (Continuous)” in the Features Guide
MEASURE Statistics Menu
1.
On the waveform screen’s MENU, tap ANALYSIS > MEASURE, or press MEASURE.
2.
Tap Statistics, or press the soft key. The following screen appears.
Set the measurement
time period.
► sec. 11.1
Turns automated
measurement on or off
► sec. 11.1
Set the source waveform
and measurement items.
► sec. 11.1
Detail setup
► sec. 11.1
Set the indicator.
► sec. 11.1
Configure Area2.
► sec. 11.1
Set Mode to ON.
Set Type to Continuous.
Measure menu
Statistics menu
Configure statistical
processing.