4-23
IM DL950-02EN
4.14 Triggering on a Wave Window Trigger
(Enhanced)
This section explains the following settings for triggering on a wave window trigger:
• Source channels
• Tolerance width, cycle frequency, and reference cycle
• Synchronization channel
• Level for detecting the start and end points
• Hysteresis
► “Wave Window Trigger (Enhanced)” in the Features Guide
Trigger Menu
1.
On the waveform screen’s MENU, tap TRIGGER > MENU, or press TRIG.MENU. A trigger
menu appears.
Select Enhanced.
Set Type to Wave Window.
See “Setting the Trigger Conditions.”
Set the trigger position, trigger delay, and hold-off
► sec. 4.2
Set the trigger mode. ► sec. 4.1
To Next Page
Loading...
