11-2
IM DL950-02EN
11.1 Automatically Measuring Waveform
Parameters
This section explains the following settings for automatically measuring waveform parameters:
Items Common to Scope Mode and Recorder Mode
• Turning automated measurement on and off
• Source waveform and measurement items
• Delay settings
• Turning period measurement on and off
• Time measurement reference level
• Measurement window and measurement time period
► “Automated Measurement of Waveform Parameters” in the Features Guide
MEASURE Menu
1.
On the waveform screen’s MENU, tap ANALYSIS > MEASURE, or press MEASURE.
Set the measurement time period.
Set statistical processing to OFF.
Continuous ► sec.11.2. Cycle ► sec. 11.3. History
► sec. 11.4.
Turns automated measurement on or off
See “Setting the Source Waveform and
Measurement Items.”
See “Setting the Time Measurement
Reference Level and 1-Cycle Mode.”
See “Setting the Indicator.”
See “Setting Measurement Time
Period 2.”
When Dual Capture Mode Is Off
When Dual Capture Mode Is On
See “During Dual Capture.”
To Next Page
Loading...
