11-3
IM DL950-02EN
Setting the Source Waveform and Measurement Items (Measure
Setup)
2.
Tap Measure Setup, or press the soft key. The following menu appears.
Set measurement items.
See “Setting the
Delay.”
Set the source waveform.*
(Slide to display waveforms
that do not fit in the screen.)
See “Copying to Specified Channels.”
Unselects all measurement items
Set the source
waveform.*
(Slide to display
waveforms that
do not fit in the
screen.)
Clears the settings
of all waveforms
When the source waveform is other than logic or XY
When the source waveform is logic
When the source waveform is XY (XY1 to XY8)
* Depending on the channel you select, you need to select sub channels and bits.
11.1 Automatically Measuring Waveform Parameters
To Next Page
Loading...
