YOKOGAWA ScopeCorder DL950 - Table of Contents

v
IM DL950-02EN
Alert marks at contents 19.1, 19.2
Contents
Manuals iii
Conventions Used in This Manual ...................................................................................................iv
Chapter 1 Setup
1.1 Setting the Operation Mode ........................................................................................... 1-2
1.2 Initializing the Settings ................................................................................................... 1-3
1.3 Performing Auto Setup ................................................................................................... 1-4
1.4 Configuring with the Application Menu ........................................................................... 1-5
Chapter 2 Channel Setup
2.1 Configuring Voltage Measurements (on modules other than 16-CH temperature/
voltage input modules) ................................................................................................... 2-2
2.2 Configuring Voltage Measurements (on 16-CH temperature/voltage input
modules) ...................................................................................................................... 2-12
2.3 Configuring Temperature Measurements (on modules other than 16-CH
temperature/voltage input modules) ............................................................................. 2-18
2.4 Configuring Temperature Measurements (For 16-CH temperature/voltage input
modules) ...................................................................................................................... 2-20
2.5 Configuring Strain Measurements ................................................................................ 2-23
2.6 Configuring Acceleration Measurements ..................................................................... 2-25
2.7
Configuring Frequency, Revolution, Period, Duty Cycle, Power Supply Frequency,
Pulse Width, Pulse Integration, and Velocity Measurements ........................................... 2-28
2.8 Configuring Logic Signal Measurements ..................................................................... 2-34
2.9 Configuring the Monitoring of CAN and CAN FD Bus Signals (/VCE option) .............. 2-36
2.10 Configuring the Monitoring of LIN Bus Signals (/VCE option) ...................................... 2-42
2.11 Configuring the Monitoring of SENT Signals (/VCE option) ......................................... 2-46
2.12 Displaying the All Channel Setup Menu ....................................................................... 2-50
2.13 Setting the Digital Filter (/G03, /G05 option) ................................................................ 2-55
Chapter 3 Waveform Acquisition
3.1 Setting Conditions for Waveform Acquisition (Scope mode) .......................................... 3-2
3.2 Setting Conditions for Waveform Acquisition (Recorder mode) ..................................... 3-4
3.3 Starting and Stopping Waveform Acquisition ................................................................. 3-8
3.4 Using the Dual Capture Feature (Scope mode only) ..................................................... 3-9
3.5 Performing Real-time Recording (SSD Recording) (/ST1 option) ................................ 3-13
Chapter 4 Triggering
4.1 Setting the Trigger Mode ................................................................................................ 4-2
4.2 Setting the Trigger Position, Trigger Delay, Trigger Delay, and Hold-off ........................ 4-4
4.3 Triggering on an Edge Trigger (Simple) in Scope Mode ................................................ 4-5
4.4 Triggering on an Time Trigger (Simple) in Scope Mode ................................................. 4-7
4.5 Triggering on an External Trigger (Simple) .................................................................... 4-8
4.6 Triggering on a Power Line Signal (Simple) ................................................................... 4-9
4.7 Triggering on a Logic Trigger (Simple) ......................................................................... 4-10
4.8 Triggering on an A to B(N) Trigger (Enhanced) .............................................................4-11
4.9 Triggering on an A Delay B Trigger (Enhanced) ........................................................... 4-13
4.10 Triggering on an Edge On A Trigger (Enhanced) ......................................................... 4-15