YOKOGAWA ScopeCorder DL950 User Manual

9-5
IM DL950-02EN
Searching Using a Zone
2.
Tap Search Mode, or press the soft key. On the menu that appears, set Search Mode to
Wave Zone.
3.
Tap Search Setup, or press the soft key. The following screen appears.
Register the search zone (Zone1-Zone4).
Set the search condition (OFF, IN, OUT).
Select the source waveform (CH1, CH16).
Set the upper and lower search
window limits.
Set the left and right boundaries of
the search window.
Set the search logic (AND, OR).
(For Zone1 to Zone4)
For items other than Logic, set for each zone.
Executing a History Waveform Search
4.
After you set all the search conditions, close the menu to return to the HISTORY menu.
5.
Tap Execute, or press the soft key. The instrument searches for the search conditions.
The soft key changes to Abort.
To abort a search, tap Abort, or press the soft key.
9.2 Searching History Waveforms

YOKOGAWA ScopeCorder DL950 Specifications

General

Brand	YOKOGAWA
Model	ScopeCorder DL950
Category	Test Equipment
Language	English