10-6
IM DL950-02EN
Setting Measurement Items (Item Setup)
4.
Tap Item Setup, or press the soft key. The following screen appears.
Select the measurement items that you want to use.
X1 Time value at Marker1
X2 Time value at Marker2
X3 Time value at Marker3
X4 Time value at Marker4
Δ(X2-X1) Difference between the time values of Marker1
and Marker2
Δ(X3-X1) Difference between the time values of Marker1
and Marker3
Δ(X4-X1) Difference between the time values of Marker1
and Marker4
Δ(X3-X2) Difference between the time values of Marker2
and Marker3
Δ(X4-X2) Difference between the time values of Marker2
and Marker4
Δ(X4-X3) Difference between the time values of Marker3
and Marker4
Y1 Vertical value at Marker1
Y2 Vertical value at Marker2
Y3 Vertical value at Marker3
Y4 Vertical value at Marker4
Δ(Y2-Y1) Difference between the vertical values of
Marker1 and Marker2
Δ(Y3-Y1) Difference between the vertical values of
Marker1 and Marker3
Δ(Y4-Y1) Difference between the vertical values of
Marker1 and Marker4
Δ(Y3-Y2) Difference between the vertical values of
Marker2 and Marker3
Δ(Y4-Y2) Difference between the vertical values of
Marker2 and Marker4
Δ(Y4-Y3) Difference between the vertical values of
Marker3 and Marker4
Cursor Value Read Mode
4.
Tap Other Setup, or press the soft key.
5.
Tap Cursor Read Mode, or press the soft key to set the marker value read mode.
The two modes available for reading Y1 and Y2 measurements are Display (display data) or
ACQ (acquisition data).
Display: The screen is divided into 1001 parts, and the maximum and minimum values
displayed on those rasters are read.
ACQ: Measurement data acquired at the sample rate of each waveform is read. When all
traces are selected, measurement data acquired at the sample rate calculated from
T/div and record length is read.
10.3 Measuring with Marker Cursors (Marker)
To Next Page
Loading...
