10-10
IM DL950-02EN
Setting Measurement Items (Item Setup)
4.
Tap Item Setup, or press the soft key. The following screen appears.
Select the measurement items that you want to use.
X1: Time value at V-Cursor1
X2: Time value at V-Cursor2
ΔX: Difference between the time values of
V-Cursor1 and V-Cursor2
1/ΔX: Reciprocal of the difference between the time
values of V-Cursor1 and V-Cursor2
Y1: Vertical value of H-Cursor1
Y2: Vertical value of H-Cursor2
ΔY: Difference between the vertical values of
H-Cursor1 and H-Cursor2
ΔY/ΔX: The amount of change in the vertical value
per unit time in the cursor range
Cursor Value Read Mode
4.
Tap Other Setup, or press the soft key.
5.
Tap Cursor Read Mode, or press the soft key to set the marker value read mode.
The two modes available for reading Y1 and Y2 measurements are Display (display data) or
ACQ (acquisition data).
Display: The screen is divided into 1001 parts, and the maximum and minimum values
displayed on those rasters are read.
ACQ: Measurement data acquired at the sample rate of each waveform is read. When all
traces are selected, measurement data acquired at the sample rate calculated from
T/div and record length is read.
10.5 Measuring with Horizontal and Vertical Cursors (H & V)
To Next Page
Loading...
