YOKOGAWA ScopeCorder DL950 User Manual

13-8
IM DL950-02EN
4.
Tap the Expression box, or select the Expression box using the jog dial or arrow keys, and
press SET. The following screen appears.
Inputs “)”.
Cursor Movement
Backspace
Clears all inputs
Confirms the input
Set constants (K1 to K8).
Set the filters (Filter1, Filter2).
Set the automated measurement values of waveform parameters to add to the expression.
Setting a Filter (Filter Setup)
5.
Tap Filter Setup, or select Filter Setup using the jog dial or arrow keys , and press SET.
The following screen appears.
Set the filter type (Gauss, Sharp, IIR).
Filter bandwidth (Low-Pass only for Low-Pass,
High-Pass, Band-Pass, Gauss)
Cutoff value (2.0% to 30.0%)
Cutoff frequency
Register as FILT2.
Register as FILT2.
Cutoff value (2.0% to 30.0%, for Band-Pass)
Cutoff frequency
Setting Constants
5.
Tap Constant(K), or select Constant(K) using the jog dial, and press SET. The following
screen appears.
Set constants.
13.4 Performing User-Defined Math (/G02 option)

YOKOGAWA ScopeCorder DL950 Specifications

General

Brand	YOKOGAWA
Model	ScopeCorder DL950
Category	Test Equipment
Language	English