19-5
IM DL950-02EN
How to Connect a USB Storage Device
When connecting a USB storage device to the instrument’s USB port, connect the USB cable
directly as shown in the figure below. You can connect/disconnect a USB cable at any time
regardless of whether the instrument is on or off (hot-plugging is supported). Connect the type A
connector of the USB cable to the instrument, and connect the type B connector to the USB storage
device. If you connect a USB storage device when the power switch is on, the device becomes
available for use after the instrument identifies it.
The instrument has two USB ports: USB-0 and USB-1. The port numbers are not fixed. The port
where the first detected USB storage device is connected to becomes USB-0. The second detected
USB storage device becomes USB-1.
USB storage
USB PERIPHERAL
DL950
General USB Storage Device Handling Precautions
Follow the general handling precautions that are provided with your USB storage device.
19.1 Connecting a Storage Device
To Next Page
Loading...
