22-8
IM DL950-02EN
Saving Data
Waveform Data
When you execute a save operation on the main unit, the sub units will also save their
waveform data in their storage areas.
“Main” is added to the normal file name on the main unit. “Sub(N)” is added on the sub units.
Setup Data
The setup data is saved in the main unit.
If the DL950s are connected with the same configuration as when the setup data was saved,
you can perform measurements with the same conditions by loading the setup data.
If the link configuration is different from that in the setup data, the setup data cannot be
loaded.
Load setup data on each unit.
Screen Capture Data
Screen captures of the main unit can be saved.
Screen captures of the sub units cannot be saved.
22.3 Starting and Stopping Waveform Acquisition
To Next Page
Loading...
