YOKOGAWA ScopeCorder DL950 User Manual

2-47
IM DL950-02EN
Configuring SENT Frame Reading Settings (SENT Port
Configuration)
3
Tap SENT Port Configuration, or press the soft key.
All Sub Channel Setup (All SubChannel Setup - SENT Data Extraction
Conditions)
4.
Tap All SubChannel Setup, or press the soft key. The following screen appears.
Turns sub channels on or off
Set each sub channel’s input to on or off.
If the data type is S&C, turn the display on or off for each bit.
SENT data extraction conditions
See “Setting All Sub
Channel
Factor/Offset.”
See “Input Setup.”
See “Setting the SENT
Format.”
See “Setting Error
Channels.”
Setting All Sub Channel Factor/Offset (All SubChannel Factor/Offset -
SENT Data Conversion Condition)
4.
Tap All SubChannel Factor/Offset, or press the soft key. The following screen appears.
SENT data conversion conditions
2.11 Configuring the Monitoring of SENT Signals (/VCE option)

YOKOGAWA ScopeCorder DL950 Specifications

General

Brand	YOKOGAWA
Model	ScopeCorder DL950
Category	Test Equipment
Language	English