Zebra ZXP 9 Series - Page 215

P1086708-001 ZXP Series 9 Card Printer Service Manual 207
ZXP Toolbox
Tools & Utilities
y smart card
y ribbon (remove ribbon prior to running this command)
y ribbon takeup (remove ribbon prior to running this command)
Speed – Sets the RPM at which the motor turns; from 100 to 1500 RPM in increments of 100.
Period – Sets the duration for which the motor runs.
Direction – Sets the direction in which the motor turns.
Rpm – Sets the RPM at which the motor turns.
Fan
These commands enable testing the functionality of the selected fan.
Command
y printhead
y transfer roller
y transfer card
On – Turns on the selected fan.
Off – Turns off the selected fan.
Transport
These commands move cards throughout the transport path to ensure/conrm proper operation of
card motors, transport rollers, and sensors.
From
y hopper
y center
y atm
y cam
To
y center
y contact
y contactless
Run – Starts the selected transport sequence.
Panel
These commands advance the selected panel (yellow, magenta, cyan, or black) to a position in front
of the printhead thereby ensuring functionality of the Ribbon Take-up Sensor, Ribbon Payout Sensor,
and Tricolor Sensor.