Zebra ZXP 9 Series

208 ZXP Series 9 Card Printer Service Manual P1086708-001
ZXP Toolbox
Tools & Utilities
Command
y yellow
y magenta
y cyan
y black
y uv (if equipped)
Run – Advances the selected print ribbon panel.
Sensor
Command
y door – Use this command to enable or disable the door sensor. This command is not
intended be used as a stand-alone command, but as one step of a multi-step calibration
process.
y contactless – For use by any agencies that perform radio/EMI certication testing.
y rd 0 – For use by any agencies that perform radio/EMI certication testing.
y rd 1 – For use by any agencies that perform radio/EMI certication testing.
y radio – For use by any agencies that perform radio/EMI certication testing.
On – Turns on the selected sensor.
Off – Turns off the selected sensor.
Modulate – Sets the current sensor to modulate.
Other Commands
Use these commands to validate the system operation for troubleshooting purposes.
Group and Command
y Initialize
 mechanism – Initializes the entire printer (this being the equivalent of opening and
closing the door); the printhead is engaged, then disengaged; the ribbon is synchronized
to the correct position, and the card transport is engaged to determine if there is a card in
the transport (sent to the reject bin if there); the transfer lm system is synchronized and
diameters are calculated; and (if installed) the smart station card motor is operated to
ensure functionality.
 lm – Synchronizes the Transfer Film and calculates diameters.
 card transport – Activates both the X andY drive motors, checks for cards in the transport
system, and sends any found to the reject bin.
y Engage – Activates the associated motor to contact/close/engage the associated assembly.
This is used in conjunction with the disengage function.
 contact – Brings the contact pad down to the position for contact encoding.