P1086708-001 ZXP Series 9 Card Printer Service Manual 61
Software
Printer Conguration
The OK button saves any changes that have been made and closes the page.
The Cancel button cancels any changes that have been made and closes the page. The Restore
Defaults button restores the default values for the page.
The Inhibit Options buttons will become active when the ribbon type and ribbon combination
supports an inhibit panel for both the front and back (e.g., a YMCKI ribbon type and a YMC Front / KI
Back ribbon combination).
The Inhibit Panel Options enables specifying areas on a card where transfer lm is not to be placed
(magnetic stripe, smart card chip, signature panel, or other non- printing areas of a card).
The Inhibit Panel Options for the front and back are the same.
Select the inhibit panel area
y Disable Inhibit – this is the default selection and will turn off the inhibit feature of the ribbon.
y Inhibit printing on magnetic stripe – places a no-print zone around the magnetic stripe area.
y Inhibit printing on smartcard contact – places a no-print zone around the smart card chip
area.
y Custom le based inhibit area – enables inhibiting printing in a custom area.
Bitmap based inhibit panel area
This option is enabled when Custom le based inhibit area is selected from the dropdown menu.
The OK button applies and saves the settings.
The Cancel button exits the Inhibit pop-up window. Changes made are abandoned.
Laminator info and options
This feature applies only to printers with laminator.
The Laminator dialog shows the laminator conguration – single- or dual-sided.
The Lamination Mode selection tells the printer how to handle the card when is goes through the
laminator.
y Default – sets the laminator into its default lamination mode.
y Top (for single- or double-sided laminators) – laminates only the top side of the card.
y Bottom (for double-sided laminators) – laminates only the bottom side of the card.
y Top and bottom (for double-sided laminators) – laminates both sides of the card.
y Pass through – sends the card through the laminator. This selection requires that the
laminator cassette(s) be removed.
y Any – laminates whatever goes to it.
The Top Laminate dialog shows the type of laminate installed on the top laminator spindle
The Bottom Laminate dialog show the type of laminate installed on the bottom laminator spindle.
When Laminate only is checked, the printer will ignore all other printing options and send the card
through to the laminator.
To Next Page
Loading...
Need help?
General
