NanoSuite 4
Agilent Nano Indenter G200 User’s Guide 4-18
Test Menu
The Test menu is available on the Test Page and Review Page only. The
Test menu, shown in Figure 4-19, is used to run, stop, and pause tests.
For quicker access to these functions, be familiar with the Stop button in
emergency situations, such as when you are concerned that a sample
may strike the tip.
Remember that lateral forces applied to the tip can cause serious
damage (see
"System Controls" on page 4-57 for further details). The
Run, Stop, and Pause commands control a test.
Figure 4-19Test menu
Next Test Segment
A test is divided into segments. You can use this command to skip the
current segment and begin the next segment.
Run Post-Sample
Selecting this command executes instructions that are defined to run
after all testing on a particular sample is complete.
To Next Page
Loading...
