Agilent Technologies Nano Indenter G200 User Manual

NanoSuite 4
Agilent Nano Indenter G200 User’s Guide 4-47
The right-click menu for the handset area depends on whether the
HandSet or the Video HandSet is displayed. You can toggle between
these two display modes by right-clicking anywhere in the handset area
and selecting either Nano HandSet or Nano Video HandSet from the
resulting pop-up menu.
Navigating the Nano HandSet Schematic
While in the Nano HandSet mode, left-clicking anywhere on the
schematic sets the target position for both viewing and testing.
Nano HandSet Right-Click Menu
Right-clicking anywhere on the handset area while you are in the Nano
HandSet mode invokes the menu shown in
Figure 4-49.
Figure 4-49Nano Handset right-click menu
Move to Target
The Move to Target command moves the sample to the target position
under the microscope. The target is defined by clicking on the
schematic, which leaves an open conical icon at the target. A red conical
icon represents the position before a move is initiated, as well as the
position during the move, as shown in
Figure 4-50 on page 4-48.

Agilent Technologies Nano Indenter G200 Specifications

General

Brand	Agilent Technologies
Model	Nano Indenter G200
Category	Laboratory Equipment
Language	English