NanoSuite 4
Agilent Nano Indenter G200 User’s Guide 4-57
Video Properties
This command will display the resolution of the video camera.
Video Format
This command enables you to change video properties via the 1394
Camera Controls dialog box. You can change the brightness, auto
exposure, sharpness, white balance, hue, and saturation of the video
image via slider controls. Video format is preset at the factory and
should not require manipulation.
Save Image...
This command is used to store the images from the handset to the hard
drive in bitmap format. This command also provides the user with an
opportunity to name the image file.
Enable Video During Test
This command is not applicable to indentation testing.
Scan Control, Tip Engage Tool, and Select Image for
Interactive
Mode
These commands are available only on the NanoVision option. For more
information, consult the NanoVision manual.
System Controls
The system controls, shown in Figure 4-61 on page 4-58, are used for
starting and stopping tests.
If the individual mode is selected, the Go button will execute the
resident method one time. If the batch mode is selected, the run button
will execute the programmed batch, which can consist of several
samples with many tests.
To Next Page
Loading...
Need help?
General
