NanoSuite 4
Agilent Nano Indenter G200 User’s Guide 4-60
Delete Sample
The Delete Sample command enables you to delete a sample from a
batch. Select any test in a sample and select Delete Sample from the
right-click menu to delete the sample from the batch.
Rename Sample
The Rename Sample command enables you to rename the current
sample via the Rename Sample dialog box.
Delete Test
The Delete Test command enables you to delete a single test within a
sample. Select any test in a sample and select Delete Test from the
right-click menu to delete the test.
Select Location
The Select Location command enables you to select the location of a
particular test on a sample.
Move to Location Under the Microscope
The Move to Location Under the Microscope command enables you
to move the location of a particular test directly under the microscope.
Select any test in a sample and select Move to Location Under the
Microscope from the right-click menu to display this location.
Real-Time Graph
Once the test is initiated, by clicking the green Go arrow in System
Controls, the Required Inputs Panel displays an overlay of the real-time
graph (shown in Figure 4-64 on page 4-61), which gives a
representation of the data collected in graphical form.
To Next Page
Loading...
Need help?
General
