NanoSuite 4
Agilent Nano Indenter G200 User’s Guide 4-59
Because most testing is done in batch mode, the right-click menu items
for this mode will be explained. For the right-click menu in individual
mode, contact Agilent technical support.
By right-clicking on the Required Inputs panel in Batch mode, the menu
in
Figure 4-63 is displayed. A number of options available here are used
to configure the system.
Figure 4-63Required Inputs panel right-click menu
Note that the panel will change as other input commands are chosen
from the menu.
Recall Last Batch
The Recall Last Batch command calls up the last batch that was run
(both the methods and the inputs).
Load Batch
The Load Batch command enables you to select a saved batch file to
run via the Retrieve Batch File dialog box. Batch files have a file
extension of *.bch.
Save Batch
After you have defined a batch using the wizard on the Define page, you
can save the batch using the Save Batch command.
Clear Batch
The Clear Batch command clears the batch from the current Required
Inputs panel.
To Next Page
Loading...
Need help?
General
