Read This First
Agilent Nano Indenter G200 User’s Guide 4
Power Requirements
100/120/220/240 VAC, 50/60 Hz
Mains supply voltage fluctuations are not to exceed 10 % of the nominal
supply voltage.
Equipment Class I, Pollution Degree 2, Installation Category II.
This equipment is for indoor use only.
Disclaimers
This User’s Guide, as well as the hardware herein described, is licensed
and can only be used in compliance with such terms and agreements as
entered in by Agilent Technologies, Inc. Users of these products
understand, except where permission is given by Agilent Technologies,
Inc. by said license, no part of this manual may be copied, transmitted,
stored in a general retrieval system, in any form or means, electronic, or
mechanical, without prior written permission of Agilent Technologies,
Inc. Information contained herein this User’s Guide is for general
information use only. Information is subject to change without notice.
Information should not be construed as a commitment by Agilent
Technologies, Inc. Furthermore, Agilent Technologies, Inc. assumes no
responsibility or liability for any misinformation, errors, or general
inaccuracies that may appear in this manual.
These specifications apply to the Agilent Nano Indenter system, and do
not guarantee the function of an experiment in these conditions.
To Next Page
Loading...
