Agilent Technologies Nano Indenter G200 - 6 Commonly Used Procedures

6-1
Agilent Nano Indenter G200
User’s Guide
Agilent Technologies
6
Commonly Used Procedures
Using NanoSuite System Agent 6-2
Defining a General Batch 6-8
Executing a General Batch 6-21
Changing the Indenter 6-25
Frame Stiffness and Area Function Calibration 6-31
General Information 6-31
Area Function Information 6-36
Frame Stiffness and Area Function Calibration: Express Test 6-45
Frame Stiffness Calibration: ISO 14577 Method 6-51
Frame Stiffness Calibration: CSM Method 6-61
Cleaning the Tip 6-68
Best Method 6-68
Alternative Method 1 6-68
Alternative Method 2 6-68
Setting the Surface Marker 6-69
Editing Input Values 6-72
Comparing Samples in Analyst 6-73
Adjusting the Vibration Isolation Table 6-77
This chapter describes commonly used procedures.