Agilent Technologies Nano Indenter G200 User Manual

2-1
Agilent Nano Indenter G200
User’s Guide
Agilent Technologies
2
Quick Start Guide
Hardware Overview 2-2
Facility and Instrument Dimensions 2-3
Specifications 2-5
Software Interface Overview 2-6
NanoSuite Software 2-6
Getting Started 2-8
Power Up the System 2-8
Launch NanoSuite 2-10
Prepare a Sample for Testing 2-11
Install the Sample Disk into the Sample Tray 2-16
Install the Sample Tray into the Indenter 2-18
Adjust the Height of the Samples 2-19
Methods and Batches in NanoSuite 2-27
First Batch Test 2-27
Second Batch Test 2-47
Third Batch Test 2-52
In this chapter, you will use your Nano Indenter G200 to perform
several tests. This Quick Start Guide is intended to convey basic
information on running the instrument and looking at data. It is not
intended to convey all of the information that you need to get the most
out of your instrument.
This Quick Start Guide introduces you to the general functions of the
instrument. You should also refer to the “Quick Start Guide” in the
User’s Manual for Compliance with ISO 14577 for a quick introduction
to running tests that are compliant with the ISO standard for
instrumented indentation testing.
If you would like further help a training video is available. Email
support at nanomechtech@agilent.com.

Agilent Technologies Nano Indenter G200 Specifications

General

Brand	Agilent Technologies
Model	Nano Indenter G200
Category	Laboratory Equipment
Language	English