NanoSuite 4
Agilent Nano Indenter G200 User’s Guide 4-40
Open Method This icon will open a previously installed method.
Save Method Use this icon to save a method after it is defined (for later use).
Batch Mode Use this icon to switch to batch mode.
Individual Mode Use this icon to switch to individual mode. It only runs tests of
individual specimens. It does not perform batches of tests on a
specimen.
Configure Real
Time Graph
Use this icon to change the Real Time Graph settings.
Edit Memo Use this icon to create or edit a Sample memo. Use it to store
comments about how the tests were run or how the specimen
performed. Memos may be included within sample reports.
Log In Use this icon to select the user profile.
Log Out Use this icon to log out of the selected user profile.
Exit Use this icon to exit the software.
To Next Page
Loading...
