Quick Start Guide 2
Agilent Nano Indenter G200 User’s Guide 2-40
Figure 2-53Click Run Batch to begin testing
32 In the resulting Review Sample Names dialog box, you can modify
the Sample Name or leave the name as is. In either case, click OK to
continue.
33 In the Review the first test location of Sample dialog box, as shown
in
Figure 2-54 on page 2-41, verify that the microscope is in the
correct location and then click OK to continue.
You can abort a test at any time by clicking the red stop button directly
below the green arrow. You have the option of aborting a single test or
aborting an entire batch. Make your selection and then click the OK
button.
To Next Page
Loading...
