Anritsu MS2830A - 3.10.3 Burst average power measurement function settings

Chapter
３
Native Device Message List
3-28
3.10.3 Burst average power measurement function settings
Device messages for burst average power measurement settings are shown in Table 3.10.3-1.
Table 3.10.3-1 Burst average power measurement function setting messages
Function Command Query Response Remarks
Measure Burst Average Power
MEAS BRSTAVGPWR
MEAS? ADJ
MEAS BRSTAVGPWR,EXE
Disable Burst Average Power
MEAS OFF
MEAS?
OFF
Noise Cancel
NOISECANCEL on_off NOISECANCEL? on_off
on_off:
= ON | OFF
Burst Average Power Start Time
BAPWRSTART time
BAPWRSTART?
time
Burst Average Power Stop Time
BAPWRSTOP time BAPWRSTOP? time
Burst Average Power
Measurement Result Query
--- RES? level