Anritsu MS2830A - [:SENSe]:FREQuency:SPAN <freq>

Chapter 2 SCPI Device Message Details
2-40
[:SENSe]:FREQuency:SPAN <freq>
Frequency Span
Function
This command sets the frequency span.
Command
[:SENSe]:FREQuency:SPAN <freq>
Parameter
<freq>
Frequency span
Range
[MS269xA]
0 Hz, 300 Hz to 6.15 GHz (MS2690A)
0 Hz, 300 Hz to 13.7 GHz (MS2691A)
0 Hz, 300 Hz to 26.7 GHz (MS2692A)
[MS2830A]
0 Hz, 300 Hz to 3.8 GHz (Option 040)
0 Hz, 300 Hz to 6.2 GHz (Option 041)
0 Hz, 300 Hz to 13.7 GHz (Option 043)
0 Hz, 300 Hz to 26.7 GHz (Option 044)
0 Hz, 300 Hz to 43.2 GHz (Option 045)
[MS2840A]
0 Hz, 300 Hz to 3.8 GHz (Option 040)
0 Hz, 300 Hz to 6.2 GHz (Option 041)
0 Hz, 300 Hz to 27.1 GHz (Option 044)
0 Hz, 300 Hz to 45.1 GHz (Option 046)
Resolution 2 Hz
(Trace Point – 1) Hz
(When Internal Signal Generator Control On/Off
is On.)
Suffix code HZ, KHZ, KZ, MHZ, MZ, GHZ, GZ
Hz is used when omitted.
Default
[
MS269xA]
6.00 GHz (MS2690A)
13.50 GHz (MS2691A)
26.50 GHz (MS2692A)
[MS2830A]
3.6 GHz (Option 040)
6.0 GHz (Option 041)
13.5 GHz (Option 043)
26.5 GHz (Option 044)
43 GHz (Option 045)
[MS2840A]
3.6 GHz (Option 040)
6.0 GHz (Option 041)
26.5 GHz (Option 044)
44.5 GHz (Option 046)