Anritsu MS2830A - :CALCulate:MARKer[1]|2|3|4|5|6|7|8|9|10[:PEAK]:Y?

Chapter 2 SCPI Device Message Details
2-142
:CALCulate:MARKer[1]|2|3|4|5|6|7|8|9|10[:PEAK]:Y?
Marker Level Query
Function
This command queries the level at the marker point. In case of delta
marker, it queries the level ratio.
Query
:CALCulate:MARKer[n][:PEAK]:Y?
Response
<level>
Parameter
<n>
Marker number
1
Marker 1
2
Marker 2
3
Marker 3
4
Marker 4
5
Marker 5
6
Marker 6
7
Marker 7
8
Marker 8
9
Marker 9
10
Marker 10
When omitted: Marker 1
<level>
Marker point level
When marker level display units are dB-system units
Resolution 0.001 dB
Suffix code None. Value is returned in the unit specified by
Scale Unit.
–999.0 is returned when no measurement is
performed or an error occurs.
When marker level display units are V-system units
Resolution 0.01 pV
Suffix code None. Value is returned in V units.
–999.0 is returned when no measurement is
performed or an error occurs.
When marker level display units are W-system units
Resolution 0.01 yW
Suffix code None. Value is returned in W units.
–999.0 is returned when no measurement is
performed or an error occurs.